Create 16 D flip-flops. It's sometimes useful to only modify parts of a group of flip-flops. The byte-enable inputs control whether each byte of the 16 registers should be written to on that cycle. byteena[1] controls the upper byte d[15:8], while byteena[0] controls the lower byte d[7:0].
resetn is a synchronous, active-low reset.文章来源:https://www.toymoban.com/news/detail-659649.html
All DFFs should be triggered by the positive edge of clk.文章来源地址https://www.toymoban.com/news/detail-659649.html
module top_module (
input clk,
input resetn,
input [1:0] byteena,
input [15:0] d,
output [15:0] q
);
always@(posedge clk) begin
if(~resetn)
q<=16'b0;
else begin
if(byteena[0])
q[7:0]<=d[7:0];
if(byteena[1])
q[15:8]<=d[15:8];
end
end
endmodule
到了这里,关于[HDLBits] Dff16e的文章就介绍完了。如果您还想了解更多内容,请在右上角搜索TOY模板网以前的文章或继续浏览下面的相关文章,希望大家以后多多支持TOY模板网!